I forgot to remove the redirect from the Authenticate php code block which is above the Server Validation code block which handles the redirect if validation fails ("failRedirect" => ""). Now the validation Show If messages show as they should.
However, the WA Server Validation (confiuration with the Validation Type: Email Address) for an email address can pass without containing "@" or "." values. It only stops if it is blank. Any sugestions?
After removing the redirect above I know have another problem and am not sure if it simply is reveling another errror. On a login page if you enter the correct username but an incorrect password you get redirected to the next page (sucessRedirect page). This was working fine before setting up the validation. When douple clicking on SecurityAssist Authenticate User Server Behavior the following error message pops up: "Error in server behavior Authenticate User: The value of the selectNode property is not a node in the document." I think that this is more a mater related to the authenication set up with Security Assist than validation? Any recomendations?