Technical Support Forums

Free, outstanding support from WebAssist and your colleagues

› WebAssist Forums › Data Bridge › DataAssist › exclamation mark next to recordset on update page

exclamation mark next to recordset on update page

Thread began 6/02/2010 8:08 pm by Gabriel Tiviroli | Last modified 6/03/2010 6:42 pm by Gabriel Tiviroli | 2632 views | 3 replies

6/03/2010 11:02 amEric Mittman

The name of the parameters is ok, it is just adding parameter to the name of the table. These parameters are used to filter the recordset for the specific record you are going to update. This is as it should be.

As for the exclamation point have you modified the recordset from the way it was created? Do you have any problems using the update page to update a record? What happens if you go to the results page, then select to update a record?

Build websites with a little help from your friends

Your friends over here at WebAssist! These Dreamweaver extensions will assist you in building unlimited, custom websites.

Build websites from already-built web applications

These out-of-the-box solutions provide you proven, tested applications that can be up and running now. Build a store, a gallery, or a web-based email solution.