Technical Support Forums

Free, outstanding support from WebAssist and your colleagues

› WebAssist Forums › Data Bridge › CSS Form Builder › How do I remove WA behaviors after attempting to use FB?

How do I remove WA behaviors after attempting to use FB?

Thread began 8/27/2009 10:54 pm by steve387748 | Last modified 12/07/2009 4:46 pm by steve387748 | 8743 views | 7 replies

8/27/2009 10:54 pmsteve387748

How do I remove WA behaviors after attempting to use FB? - RESOLVED

I tried to use Form Builder on an existing simple login form that I had created by hand and that was working with spry validation widgets.

After following directions for using an existing form FB created a form that was way too wide for the section of the page where I had the original form located. It added lots of divs and of course those aren't recognized by DW which caused the look and feel to break.

Then I decided to just leave the form alone and did a bunch of Undos (until there were no more that could be done). However, when looking at the Bindings panel in DW, I see that the FB frmLogin and Server Variables are still listed in the Bindings panel. How would I remove this so that I can get the page back to its original state?

steve

Build websites with a little help from your friends

Your friends over here at WebAssist! These Dreamweaver extensions will assist you in building unlimited, custom websites.

Build websites from already-built web applications

These out-of-the-box solutions provide you proven, tested applications that can be up and running now. Build a store, a gallery, or a web-based email solution.