How do I remove WA behaviors after attempting to use FB? - RESOLVED
I tried to use Form Builder on an existing simple login form that I had created by hand and that was working with spry validation widgets.
After following directions for using an existing form FB created a form that was way too wide for the section of the page where I had the original form located. It added lots of divs and of course those aren't recognized by DW which caused the look and feel to break.
Then I decided to just leave the form alone and did a bunch of Undos (until there were no more that could be done). However, when looking at the Bindings panel in DW, I see that the FB frmLogin and Server Variables are still listed in the Bindings panel. How would I remove this so that I can get the page back to its original state?